Home · Starter settings · xTool S1
xTool S1: starter settings
Enclosed diode laser with 10W, 20W and 40W blue modules and an optional 2W infrared module for metal and plastic marking.
Current deal
Recommended first burn settings
Lindenholz 3mm: cut
Lindenholz 3mm: cut
Schwarzes Acryl 3mm: cut
Black PLA (3D printed): engrave
White plastic (Apple USB adapter type) – dark mark: mark
Buyer FAQ
How often should I clean the lens?
xTool's interval for the protective lens is about every 2 hours on the 10W module, 1 hour on the 20W and 30 minutes on the 40W. Smart Air Assist helps it stay clean longer.
Does the S1 need a grounded outlet?
Yes. xTool says not to plug it into an ungrounded outlet.
Can the S1 do relief or deep engraving?
No.
Is there a daily usage limit?
No, as long as you follow the lens cleaning schedule.
Which materials can't the diode cut?
Clear materials like clear acrylic and glass, mirrored surfaces, mostly blue materials and some extruded acrylic.
Can the 2W IR module cut plastic or metal?
xTool doesn't recommend cutting with it. It can cut 0.05 mm aluminum, stainless and copper, but long metal cuts can overheat parts. Max engraving depth is about 0.05 mm.
2W IR or 20W blue for stainless steel?
At 100% they engrave about the same depth, but only the IR engraves gold, silver and aluminum without marking paint.
Can I swap modules with the power on?
No. Change laser modules with the machine powered off.
First-week setup and maintenance
- If your material is in XCS, use its preset first. Otherwise raise power, lower speed or add passes, and lower the focus by 3 mm for cutting.
- Put the slats or honeycomb panel under anything you cut to reduce back-burn and protect the baseplate.
- Use Auto-measure for the distance. If you measure by hand, xTool says to subtract 100 mm from your measurement and enter that as Distance in XCS.
- Use the S1 air assist (level 4 for cutting) on thick or tough materials.
- Below 10 °C, warm the IR module up by running a project first. xTool lists preheat times of 7 seconds to 2 minutes, depending on the room.
Common beginner mistakes
- Letting the protective lens get dirty, which cuts power and can damage the lens.
- Cutting clear, mirrored or blue materials with the diode.
- Running slow and hot, which scorches edges. xTool suggests more speed, less power or fewer passes.
- Skipping the honeycomb or slats when cutting.
Full settings list
All 10 xTool S1 settings · All 2 xTool S1 (2W IR module) settings