Home · Starter settings · ComMarker B4 MOPA
ComMarker B4 MOPA: starter settings
Galvo fiber marker. These starter settings are for the 60W JPT MOPA version, from one owner's tested LightBurn library.
Recommended first burn settings
Black anodized aluminum business cards (image + text): mark
Steel (Engrave): engrave
Steel (White Finish): engrave
Brass (Engrave): engrave
Titanium (Engrave): engrave
Titanium (Anneal Gold): mark
ABS (black mark): engrave
White plastic (common, dark mark): engrave
Buyer FAQ
What laser class is it? Do I need goggles?
The B4 uses a Class IV laser that can injure eyes and burn skin. ComMarker recommends laser goggles.
What materials does ComMarker recommend?
Metals like stainless steel, aluminum, bronze, brass and alloys, and plastics like PP, PE and ABS. Don't engrave materials whose properties you don't know.
What room conditions does it need?
Dry and ventilated, 5 to 35 °C (40 to 95 °F), humidity no higher than 70%.
Which LightBurn version and license do I need?
LightBurn V1.3.01 or newer; older versions aren't compatible. LightBurn has a 1-month free trial, then you need a Galvo license key.
How do I set focus?
Raise or lower the laser head until the three red light points overlap. The red lights are factory-corrected for the 110 mm lens, but ComMarker warns shipping can shift them, and the manual explains how to re-align them.
What MOPA settings does LightBurn need?
For the JPT MOPA, set frequency Min 1 / Max 4000, turn on Galvo 2 and Enable Q-Pulse Width Setting, with fiber type IPG_YLP or JPT.
The red preview works but marks are faint or missing. Why?
Adjust the focal length using the manual's focus steps. If that doesn't fix it, contact ComMarker after-sales.
Why doesn't the preview line up with the mark?
Import the calibration file from the USB drive that came with the machine. ComMarker can email a new one for your serial number.
First-week setup and maintenance
- Remove the plastic cover from the field lens before marking. Otherwise the laser can burn it.
- Import the calibration (.cor) file from the included USB drive so the preview matches the mark.
- Use a stable power supply with less than 5% voltage fluctuation.
Common beginner mistakes
- Leaving the machine unattended while it runs.
- Marking with the field lens cover still on.
- Using LightBurn older than V1.3.01, or without a Galvo license.
- Marking materials with unknown properties.