Home · Starter settings · Bambu Lab H2D / H2S laser
Bambu Lab H2D / H2S laser: starter settings
The laser modules for Bambu's H2 printers: 10W on the H2S, and 10W or 40W on the H2D. Settings below are Bambu's own presets for its materials.
Current deal
H2S Laser Full Combo
Recommended first burn settings
Bambu Basswood Plywood 3mm: engrave
Bambu Basswood Plywood 3mm: cut
Bambu Basswood Plywood 3mm: engrave
Bambu Basswood Plywood 3mm: cut
Bambu Basswood Plywood 3mm: cut
Bambu Opaque Glossy Acrylic - Black 3mm: cut
Bambu Opaque Glossy Acrylic - Black 3mm: engrave
Bambu MDF Board 3mm: cut
Bambu Cork Sheet 2mm: cut
Bambu Cardstock - Black 250g: cut
Buyer FAQ
Which laser can each printer use?
The H2S supports the 10W laser and cutting, but not the 40W. The H2D supports 10W and 40W.
10W or 40W?
Both are blue diode lasers. On basswood plywood the 10W cuts up to 5 mm and engraves up to 400 mm/s; the 40W cuts up to 15 mm and engraves up to 1000 mm/s. The work area is 310 × 270 mm with the 10W and 310 × 250 mm with the 40W.
What materials can it laser?
Wood, bamboo, cork, MDF, paper and cardstock, felt, PU leatherette and some opaque acrylic can be engraved and cut. Stainless steel, aluminum, plated or painted metal, opaque glass, ceramic and shale are engrave-only. Blue, white and transparent acrylic can't be processed.
Can I add a laser to a printer I already own?
Bambu says upgrade kits exist or are planned for non-laser H2S and H2D printers, using an external air pump.
Will laser smoke hurt the printer?
Bambu says the H2D's exhaust removes smoke and dust, and with regular cleaning the effect on precision is negligible.
Why do I have to calibrate before lasering?
Setup and mount calibration measure the laser focus position. The laser and cutter won't work until they're done.
Can I laser straight on the base without the slats or grid?
Bambu doesn't recommend it. You can only surface engrave, not cut, and height measurement will read about 15 mm low.
First-week setup and maintenance
- Before a laser job, check that the XY axes and the nozzle and toolhead camera lenses are clean. Wipe them with non-woven cloth afterward.
- If a cut doesn't go through, check that the air pump is connected and the air assist nozzle is blowing.
- For small objects, select the right material and enter its thickness before the photo step, so a failed photo falls back to your thickness.
Common beginner mistakes
- Leaving the machine unattended during a laser job, or keeping flammable or explosive items nearby.
- Lasering blue, white or clear acrylic. It won't process.
- Skipping the slats pack or grid panel.
- Expecting the 40W module to fit an H2S.
Full settings list
All 30 Bambu Lab H2D settings · All 15 Bambu Lab H2S settings