EM Smart Basic 1 / Dark / black or anthracite 3D-printed plastics (PLA, PETG, ABS and similar)

Dark / black or anthracite 3D-printed plastics (PLA, PETG, ABS and similar) on EM Smart Basic 1

youtube engrave
Test on scrap first. Settings are starting points from the linked source.
Machine
EM Smart Basic 1
Laser type
fiber
Wattage
20W
Material
Dark / black or anthracite 3D-printed plastics (PLA, PETG, ABS and similar)
Operation
engrave
Power
50%
Speed
2000 mm/s
Passes
1
Frequency / pulse
20–60 kHz (he saw almost no difference across that range on these plastics)
Notes
mpoxDE Aurora Whisper transcript: decent results on fine lettering with a 20W fiber at 2000 mm/s and 50% (10 W). He says ~10 W is enough for almost all plastic markings and that frequency (limited to 20–60 kHz on this machine) barely changed the mark. Best on black/anthracite; pigment matters more than polymer type. Examples from the same tests: Nobufil Astro PETG black gave the highest contrast (almost white); most other black PLA/PETG/ABS marked similarly; eSUN black PETG showed no visible result; Bambu Lab orange HiFlow PETG marked gray; Nobufil X-ABS turquoise worked; Eryone dark red PETG showed results; Prusa orange PLA, Prusa red PLA, lighter-turquoise Polymaker PLA, and all Prusa Galaxy colors showed no mark even when he turned a MOPA all the way up. LightBurn material tests per filament. Ventilate; do not laser PVC. On a dark-gray PETG Voron logo with his 20W EM Smart MOPA he used a 0.05 mm line interval and found a second pass in a different direction helpful on a textured print surface; he did not give a MOPA power/speed pair for that example.
Source: mpoxDE
Summarized from the linked source. Always test on scrap before production runs.