Aluminum Oxide on LaserPecker LP5
official engraveTest on scrap first. Settings are starting points from the linked source.
Machine
LaserPecker LP5
Laser type
diode
Material
Aluminum Oxide
Operation
engrave
Power
54%
Speed
Depth 58% (LaserPecker depth, not mm/s)
Passes
1
Notes
[fill mode] Official LaserPecker LP5 recommended starting settings table (450 nm diode, focal length 152 mm column), Fill at 2k resolution. Values shown as Power%/Depth%; LaserPecker notes results vary by firmware (settings also in LDS 2.9.x+ / app 5.9.x+).
Source: LaserPecker