xTool M2 / Slate Coaster

Slate Coaster on xTool M2

guide engrave
Test on scrap first. Settings are starting points from the linked source.
Machine
xTool M2
Laser type
diode
Wattage
10W
Material
Slate Coaster
Operation
engrave
Power
42%
Speed
360 mm/s
Passes
1
Line interval / DPI
160 lines/cm
Notes
L3D Accessories tested recipe L3D-M2-003: Slate, Photo / bitmap · Jarvis. Photos. Bi-directional, min output power 3%, air assist 15%. Rock Stone material preset, then Auto Adjust in the image editor to invert and optimise the photo. Run a small test first.
Source: L3D Accessories
Summarized from the linked source. Always test on scrap before production runs.